E.C.A. Proteus Plus Blue 24 kW Installation And Operating Instructions Manual - Control Panel
CONTROL PANEL
LCD Display
Malfunction Warning LED
•
..____
-
-
-ı-
l
·
Domestic Hot
Water
Temperature
Adjusting Button
1} Pasitian Se/ectian Buttan
Central Heating Water
Temperature Adjusting
Button
Figure 20
Position Selection
Button
it enables opening/closing of your device, selection of summer/winter position, and resetting of the
device.
inter Pasitian: Turn the position selection button to the left, to the "
[<-
" symbol. in this
position, you can enable the heating up of central system and also heating up of the running water.
-l;ummer Position: Turn the position selection button to the right, to the "
" symbol. in this
position, you can enable the heating up of only the running water.
• Closure Position: Take the position selection button to "• - OFF" position. in this position, the
operation of your device will end.
?
Reset Position: When your device breaks down, the malfunction warning LED will start to
blink, and reset phrase will appear on the left hand side of the LCD display along with the
"?
,
symbol. in this case, take the position selection button to "OFF - Reset" position, and turn to
summer or winter position after waiting for 5 seconds. lf the malfunction is continuing, repeat this
operation for a few times. lf the malfunction is stili continuing despite resetting, consult to the
closest E.C.A. service.
2) Central Heating Water Temperature Adjusting Buttan
While the position selection button is in winter
"f"
position, you can select a comfort temperature
as you like in between 40
°
C - 80
°
C by turning the central heating water temperature adjusting button
in between min. and max.
3} Damestic Hot Water Temperature Adjusting Buttonlf-
While the position selection button is in summer " "or winter"
f
"position, you can select a running
water temperature in between 35
°
C - 64
°
C by turning the domestic hot water temperature
adjusting button in between min. and max.
4) LCD Disp/ay
You can see ali the operation functions over the LCD display on the control panel of the device.
While the device is in closed position, there will not be any view on the LCD display.
While your combi boiler is operating in central heating position,
"
1
1."
symbol will appear on the
right bottom corner of the LCD display, and the temperature of water in the central system will be
seen numerically on the display.
23