Ea2 BL506 User Manual - page 10
ENGLISH 7
ENGLISH 8
7.3 Snooze Alarm Clock Function:
• Press “ ALARM” button (B3) once see the alarm time (“AL” shown on the LCD):
• Press “Alarm” twice, to turn ON/OFF the alarm function. When alarm on,
shown
on the LCD.
• When viewing alarm time, hold “ALARM” button (B3) for 3 seconds to enter the Alarm
Time setting. Press “▲” (B6) or “ ▼ ” (B7) button to adjust the alarm time, and press
“ALARM” button (B3) to confirm the setting.
• When alarming, press “SNOOZE/LIGHT” (B1) button to activate snooze alarm. “ ”
flash on the LCD. The alarm will snooze for 5 minutes, then it alarms again. This
snooze function can be enabled for maximum 7 times.
• Except “SNOOZE/LIGHT” (B1) button, press any button to stop the snooze alarm.
8. Low batteries indication:
The low battery icon “
” will appear at particular channel indicating that thermo sensor
unit of the channel is in low battery status. The batteries should be replaced.
9. Projection & Backlight
• Press “SNOOZE/LIGHT” (B1) button, the projection and backlight shine for around 20
seconds.
• When DC adaptor plug in, push “PROJECTION ON/STANDBY” (B9) slide switch
to “ON”, the projection and back light will turn on and not auto off. Push the switch
to “STANDBY”, press “SNOOZE/LIGHT” (B1) button to turn on the back light and
projection for around 20 seconds.
Indoor Data:
Temperature range:
-5 to 50°C [23 to 122°F]
Temperature Units Measured:
°C or °F [switchable]
Outdoor Data:
Transmission distance: (open area)
30m @ 433MHz
Temperature range:
-40 ~ 50°C [-40 ~ 122°F]
Mount:
table
Main Unit Dimensions:
W158 x h87x d48 mm
Thermo Sensor Dimensions:
w65 x h84 x d18 mm
Battery Requirements:
Base Station [indoor]:
3 x AAA batteries
Sensors [outdoor]:
2 x AAA batteries
Adaptor Output:
DC 4.5V, 250mA
11. Specifications
10. Precautions
• Use a pin to press the reset button (B4) if the Unit does not work properly.
• All Setting Modes will automatically exit in 15 seconds without any adjustment.
• Avoid placing the clock near interference sources/metal frames such as computer or
TV sets.
• Do not expose it to direct sunlight, heavy heat, cold, high humidity or wet areas
• The outdoor sensor must not be set up and installed under water. Set it up away direct
sunlight and Rain
• Never clean the device using abrasive or corrosive materials or products. Abrasive
cleaning agents may scratch plastic parts and corrode electronic circuits