Easy-Kleen AS152E Alternate Spec Owner's manual - Operating Instructions
9
Cold Water Electric • Rev.
17/10/2016
The management & staff at Easy-Kleen are proud of the equipment that we design and
manufacture, and we thank you for making us your # 1 choice in pressure washers. If you have
any questions please do not hesitate to call us, 1-800-315-5533.
Our goal is that you will be satisfied with the performance, quality, and service you receive from
Easy Kleen and that if you need to replace this machine in years to come, you will give us the
opportunity to continue supplying equipment to your company.
PLEASE READ MANUALS CAREFULLY BEFORE USING MACHINE. EXAMINE
MACHINE AND CRATE CAREFULLY FOR SHIPPING DAMAGE OR MISSING
PARTS. REPORT PROMPTLY ANY SHORTAGES OR DAMAGE CLAIMS TO
FREIGHT CARRIER OR DEALER.
OPERATING INSTRUCTIONS
1.
Perform pre-start maintenance
inspection on all applicable systems prior to operating the
machine. This is essential for the safe, effective and efficient operation. You will get optimum
performance from your system ONLY if these instructions and inspections are followed. Any
indication that the pressure washing system was not operated and maintained according to these
instructions may cancel the manufacturers’ warranty.
Controls
– Make sure all controls turned to the off position.
Pump – Oil level
- Level the pressure washer. Be sure oil level in the pump is correct on dip
stick. If the level is low, add the correct oil to the proper level.
USE ONLY
SAE 30 W NON-
DETERGENT OIL OR HYDRAULIC 68. DO NOT OVER FILL.
Visually inspect all electrical components to assure they are in good condition, showing
No signs of exposure, breakage or splicing.
Visually inspect all hoses, nozzles and guns to assure they are in good condition. If
replacements are necessary they must be rated to withstand the machines operating
pressure and temperatures.
2.
Attach high-pressure hose
to water outlet quick connector. Attach the other end of high
pressure hose (with quick coupler) to spray gun. Ensure that quick disconnect connections are
tightly locked together. Apply a sharp pull on hose to confirm they are secured.
Attach wand nozzle
specific to task requirements (i.e. chemical or pressure wash).
[Quick Coupling Operation – Pull back sleeve end and insert male end into nozzle quick coupler,
release sleeve and confirm connection by pulling on nozzle].