Easymount Cold EM-1400 Product Instruction Manual - page 8
8
Feeding the Film
1. Using the pressure handle raise the
upper roller
7. Press the ‘forward’ drive button.
The loading card should be pulled
through the machine
8. Ensure the top and bottom films
match each other and dont overlap
left to right. If they dont, loosen the
mandrel core grip and slide the film
left/right until they match and then
re-tighten
Laminating - COLD
1. Plug in the foot pedal
2. To drive the machine press either
the drive button (left hand arrow)
continuous drive or step button
(middle arrow) for the foot switch.
The foot switch over rides the
magic eye, it is advisable to start the
machine & then press the continuous
button when running
3. The films will then begin to be
drawn through the machine
4. You can adjust the rate at which
the machine laminates by turning
the speed control knob
2. Place vinyl/print through rollers
from feed tray and onto back plate
3. Pull laminate over the top roller
and push through the rollers
4. Using the pressure wheel bring the
rollers down until the handle goes in
neutral mode and slight resistance
is felt
5. Using the safety cutter provided
slice between the release paper and
film cutting only the release paper
6. Apply double sided tape to the
release liner take up core and attach
release liner
9. The machine is now in its loaded
state you can lower the feed table,
you are now ready to laminate your
prints.