Eberspächer B3LC User Manual - page 11
11
Installation
3
Installation and location
The heater is suitable and certified for installation in
parts of vehicles used by persons.
Installation in the cab or passenger compartments of
coaches or buses with more than 9 seats is not
allowed.
When installing in compartments used by persons, the
exhaust, combustion air and fuel pipes in these areas
must not have any detachable connections and must
be routed splash-waterproof in the breakthroughs.
For this reason, the heater can be mounted with its
foot using the flange seal in the foot to the vehicle
floor or to an outer wall of the vehicle.
The electronic control is integrated in the heater
which makes wiring during installation much easier.
Please note!
• When installing the heater, always make sure there
is sufficient clearance left for intake of the heater air
and for dismantling the glow plug and controller.
• Observe the regulations and safety instructions for
this chapter, given on page 4 – 7.
Installing the 24 V heater in a vehicle for
the transport of dangerous goods as per
ADR / ADR99
Heaters (24 volt) are allowed to be installed in
vehicles used for the transport of dangerous goods as
per ADR / ADR99.
The heater fulfils the regulations of ADR / ADR99 with
the corresponding electrical wiring, see circuit
diagrams at the end of this manual.
Detailed information about the regulations of ADR /
ADR99 is contained in the leaflet no.
25 2161 95 15 80.
Please note!
When the heater is to be installed in vehicles for the
transport of dangerous goods, the regulations of ADR
/ ADR99 must be observed.