Eberspächer EasyStart Select Installation Instructions Manual - page 4
4 | VEhICLE hEATERs – TEChnICAL DOCuMEnTATIOn
please read first
before you start to install the Easystart select,
always read through these installation instruc-
tions carefully.
These installation instructions contain impor-
tant information, which you need to install the
Easystart select.
safety instructiOns
danger!
Always note and follow all information and
notes, especially the safety instructions in
this document and in the heater's technical
description!
intended use
The Easystart select is used to select the
operating mode, to set the operating time, and
to switch On / Off the heater installed in the
vehicle.
please nOte!
Improper use and use outside the specified
purpose cancels all liability and warranty.
1 InTRODuCTIOn
general infOrmatiOn
VEnTILATIOn OpERATIng MODE
In VEnTILATIOn mode the fan of water heat-
ers is actuated by directly bypassing heating
mode. If the symbol is not displayed the
VEnTILATIOn function is not available for the
heater.
If you have any further questions about
VEnTILATIOn mode, please dial the service
telephone number
see page 17
.
TEMpERATuRE sEnsOR
The temperature sensor that is installed in
the heater and which controls the tempera-
ture inside the vehicle is also used for the
Easystart select temperature display.
InsTALLATIOn InsTRuCTIOns FOR spECIAL
FunCTIOns
These installation instructions describe
the standard configuration. For details of
enhanced configuration of the Easystart
select and for special functions such as com-
binations with various Easystart control units,
installation in ADR vehicles, operating the
heater and additional unit, etc. the “special
Functions and Diagnosis” installation instruc-
tions are available to view and to download
from
www.eberspaecher-standheizung.com/
download
.