Eberspächer EasyStart Select Installation Instructions Manual - page 7
VEhICLE hEATERs – TEChnICAL DOCuMEnTATIOn | 7
2 InsTALLATIOn
installing the easystart select
cautiOn!
When drilling the fixing and connection holes
in the dashboard, concealed components
behind it could be damaged.
Î
Check that the space behind the installa-
tion area is free from components.
Install the Easystart select in a suitable place
on the dashboard, within the driver's view and
connect as shown in the sketch
on page 8
and the circuit diagram
from page 15
.
use the template supplied to position and
drill the two holes ø 6.5 mm and ø 9 mm.
The foam underlay can be used if neces-
sary to level out unevenness. To do this,
pull off the protective film and stick the
foam underlay onto the installation area.
Then pull off the second protective film.
Feed the lead harness from the Easystart
select through the drillhole ø 9 mm.
Insert the Easystart select with expansion
plug into the drillhole ø 6.5 mm.
screw the fixing screw into the expansion
plug and therefore fasten the Easystart
select.
installing the tab cOnnectOr Of the
easystart select lead harness
plug the tab connector of the Easystart
select lead harness into the 4-pin con-
nector housing (for details of connector
housing pin assignment
see page 8
and
page 9
).
push the contact locking device into the
connector housing.
please nOte!
When installing the connector, ensure that the
locking tangs always face the middle of the
connector. Only in this position do the tangs
latch into the housing (see sketch above).