Echo EDR-2400 Operator's Manual - page 10
8
IMPORTANT
Stored fuel ages. Do not mix more fuel
than you expect to use in thirty (30) days,
ninety (90) days when a fuel stabilizer is
added.
Stored two-stroke fuel may separate.
ALWAYS shake fuel container thoroughly
before each use.
On
Stop
Throttle trigger
Air cleaner
Fuel return line
Purge bulb
Push
(Open)
RUN
START
(Close)
NOTE
When engine does not stop, shift choke
shutter to close position.
Check and repair stop switch before starting
the engine again.
STARTING COLD ENGINE
STOPPING ENGINE
STARTING WARM ENGINE
•
Set throttle trigger in idle position.
•
Place ignition switch in STOP position.
•
Stand the engine upright on a level surface.
•
Place ignition switch in ON (START/RUN)
position.
•
Push purge bulb 3 to 4 times (or until fuel is
visible in fuel return line).
•
Shift choke shutter to close position.
(START)
•
Open throttle trigger to a fast idle.
•
Pull recoil starter until the engine fires.
•
Shift choke shutter to full open position,and
if necessary, start the engine again and
allow to warm up before using.
- The clutch engages at approximatery
3500 rpm. therfore the cutter may rotate at
fast idle engine speed.
choke lever
•
Place ignition switch in ON (START/RUN)
position.
•
Pull starter handle until the engine fires.
- Do not use the choke.