Echo EDR-2400 Operator's Manual - page 11
9
•
This model is equipped with reverse
rotation mechanism.
•
When drilling, set shift lever down to
clockwise (CW) rotation position.
•
If bit is locked due to deep penetration
during drilling operation, set shift lever up to
counterclockwise (CCW) rotation position
and operate reversed for easy pulling-out.
REVERSE ROTATION
•
When changing direction of drill rotation,
operate as follows:
- Return engine to idle.
- Engine shift lever to CW or CCW
position with a slight acceleration of the
throttle trigger.
To properly lock the gears in the gears in
the gear case.
- Do not operate shift lever forcibly when
changing rotation direction.
Shift lever
Clockwise (CW)
Counterclockwise
(CCW)
NOTE
Do not shift from forward to reverse (or vice-
versa) while the chuck is turning.
Failure to do so may cause unit damage.
Always release throttle and allow the unit to
return to idle before shifting.
Do not stand close to drill or chuck with your
body or clothes while operation.
When drilling, ensure that no power cable or
other obstacle exist.
WARNING DANGER
•
WHEN THE DRILL CAN NOT PULL
OUT FROM THE WOOD, DO NOT TRY
TO PULL OUT THE DRILL BY
FORCE.
•
WHEN CHANGING THE BIT, ENSURE
TO STOP THE ENGINE.
•
AFTER A JOB, BIT AND GEAR
CASING MAY BE HEATED, DO NOT
TOUCH THEM WITH BARE HANDS.