1. DL manuals
  2. Echoflex
  3. Temperature Controller
  4. RTS-1T-nW
  5. Installation Manual

Echoflex RTS-1T-nW Installation Manual

Summary of RTS-1T-nW

  • Page 1

    Rts echo flex powered by etc resonate wireless temperature sensor installation guide this guide covers all resonate temperature sensor models. The resonate temperature sensor product family includes: rts-1t-nw temperature sensor rts-1h-nw temperatureandrelativehumiditysensor rts-1ts-nw, temperature ...

  • Page 2

    Page intentionally left blank.

  • Page 3

    3 temperature sensor description the temperature sensor (also referred to as the sensor in this guide) is a wireless, energy harvestingsensorthatmonitorsroomtemperatureintherangeof0-40°c(32°-104°f) andrelativehumidityintherangeof0-100%.Thesensorisintendedforindooruseonly. Some models have a temperat...

  • Page 4

    4 occupancy button - (rts-2hs models only) users can override a room occupancy statebypressingtheoccupancybuttononthelowerrightedgeofthesensor. Led operation - leds are on the right side of the solar panel. The red led will flashwhenthelinkoroccupancybuttonispressed.Seetestoperatingmodes forfurtherl...

  • Page 5: Test Operating Modes

    5 within range of the temperature sensor to be linked. The sensor is a solar powered device that absorbs energy through a solar panel storing it for use during low light periods. Before assigning the sensor to a receiver/controller, the device must be exposed to a good light source for a minimumof2h...

  • Page 6: Light Level Test Table

    6 releasedthetestmodebutton,placethesensorunderalampwithatleast100foot- candles (1000 lux) for 1 hour before retrying. Light level test table the green led will blink according to the energy produced by the solar cell blinks lux foot candles time to fully charge discharge time 0,1 belowoperatingleve...

  • Page 7: Installing Wireless Devices

    7 installing wireless devices carefulplanningisneededwhenlocatingthereceiversandtransmittersbased ontheconstructionmaterialsinthespaceandpossibilityoftenant’sfurniture disruptingthetransmissions. The temperature sensor should be installed in the space where the receiver is mounted and connected to t...

  • Page 8: Regulatory Statements

    8 regulatory statements fcc part 15.231 (315 and 902 mhz models only) containsfccid:szv-stm300corszv-stm300u contains ic: 5713a-stm300c or 5713a-stm300u theencloseddevicecomplieswithpart15ofthefccrules. Operationissubjecttothefollowingtwoconditions: (i.) this device may not cause harmful interferenc...