Echoflex RTS-1T-nW Installation Manual - page 4
4
Occupancy Button - (RTS-2HS models only) Users can override a room occupancy
statebypressingtheoccupancybuttononthelowerrightedgeofthesensor.
LED Operation - LEDs are on the right side of the solar panel. The red LED will
flashwhentheLinkorOccupancybuttonispressed.SeeTestOperatingModes
forfurtherLEDinformation.
Transmitting Values - The temperature sensor will transmit a telegram when:
• 10 sample periods have been completed or
• whenthefanswitchoroccupancybuttonareusedor
• whenthetemperaturevaluedifferencefromthelasttransmittedvalueis
greaterthan0.3°C,(0.5°F)orthehumidityvaluedifferencefromthelast
transmittedvalueisgreaterthan3%.
Installing the Temperature Sensor
The temperature sensor can be mounted on any surface; glass, stone, concrete,
wallboard,cubiclepartitions,etc.Thesensorcanbemountedusingscrews(not
supplied) through the removable back plate (2 keyholes or using double sided
tape or Velcro™ (not supplied).
The mounting location of the wireless transmitter is important as this will
directlyaffectthereceiversreceptionofthetelegrams.Beforeinstalling,refer
tothesectionsintheguidedetailingtheinstallationofwirelessdevices,layout
tipsandthetestoperationmodes.
1. The sensor has a removable back plate.
The back plate has a security feature which
requires a tool for the removal of the
device from the backplate. To remove the
sensor,insertaflatheadscrewdriver,intothe
slot and exert torque on the key tab to separate
the backplate from the housing body as shown in
the photos. Once the tab is free,
pull the body away from the back
plate.
2.
Mount the back plate to
a bracket or the wall surface
inaverticalorientationwith
theplastickeyonthebottom.Therearekeyholesinthe
back plate that mate with standard electrical box screw
patterns.Alternatively,youcanmountthesensorusing
double sided tape or Velcro® (not supplied).
3.
Once the back plate has been secured to the wall or
mountingbracket,alignthetwotopalignmenttabsonthe
back plate with the temperature sensor body and press the lower edge
overtheplastickeyuntilitclicksinplace.
Linking the Temperature Sensor to a Receiver
This process requires the controller or receiver to be mounted and powered and