Echoflex RTS-1T-nW Installation Manual - Test Operating Modes
5
within range of the temperature sensor to be linked.
The sensor is a solar powered device that absorbs energy through a solar
panel storing it for use during low light periods. Before assigning the sensor to
a receiver/controller, the device must be exposed to a good light source for a
minimumof2hours,orinstalltheoptionalstartassistbattery(notsupplied).
1. Remove the sensor from the back plate by pressing in
on the tab on the lower edge and pulling away from
the back plate.
2. ActivateLEARNorLINKmodeatthereceiver,if
necessaryrefertothemanufacturersdocumentation.
3. PressthetemperaturesensorsLink(Teach)button.
4.DeactivateLEARNmodeatthereceiver.
Installing or Replacing the Battery
The battery is not required for normal operation when the RTS receives
adequatenaturalorartificiallight.Thebatterycanbeusedduringinstallation
(start assist).
1. Remove the sensor from the back plate by pressing the key on the lower
edge of the sensor body and pull the body away from the back plate.
2. Toremoveoldbattery:Usingasmallflatheadscrewdriverorpenasalever,
insertpointedendundertheclearplasticbatteryretainingclip’sedgeand
poptheclipoff.
3. Installorreplacethebatteryintheclipwithanew
CR2032coincellbatteryinsuringthepositiveside(+)
will be facing up.
4.Align the two straight edges of the retaining clip with
thebatteryholderandpresstheclipinwithyour
finger.
Test Operating Modes
EnsuretheRTSisfullychargedbeforeenteringtestmodes.Insertingabattery
during test modes is also recommended. The following tests can be selected
when in test mode.
Light Level Test: provides visual feedback of the
immediate energy produced by the solar panel.
1. To enter Light Level Test mode, press and hold the
occupancy/testbuttonfor6seconds.Thegreen
LED will begin to blink.
2. Pressthetestbuttonagainfor6secondsto
select Light Level Test. The green LED will blink
inaccordancetothelightlevelitisdetecting.
Thiswillchange(2secondlagtime)asyoumovethesensortoareaswith
differentlightlevels.Seefollowingblinkindicatortable.
Note:Enteringtestmodesection:IftheredLEDblinks(nogreenLED)afteryouhave