Eclipse ES-V600 User Manual - page 16
15
System Settings – See MONITOR DESCRIPTION & BUTTON MAP
At standby mode, press and hold “Image capture” button for 5 seconds to get into the set-up mode as below.
1
st
line: Chime Duration Time
2
nd
line: Character Add: Enable/Disable
“DOOR1/DOOR2” on monitor screen)
3rd line: Main/Sub Multiple Monitor set up
HOLD button 6 on MAIN or SUB for 3 seconds
At this point, pressing “Image capture” button will move to
the next value until Intercom/Main menu. Use “◄►” (button 5) to select Main or Sub.
When enter main panel selection
。When cursor is at
“MAIN”status, press button two seconds and then you will enter the second menu interface:
1
nd
line: Setup doorbell active numbers
2
rd
line: Setup video extending channels numbers
CHIME TIME SET: Chime Duration
The default chime duration is 30 seconds. To adjust this time:
When the curser flashes at the first character of date, keep pressing “Image capture” button to go to the chime
duration setting. Press “◄►” button to adjust the chime time. The chime duration is from 10 – 90 seconds.
CHAR ADD SET :
At standby mode, press “Image capture” button to get into the main menu setting interface. Move the cursor to
the 5
th
line, press “◄►” BUTTON to choose Enable or Disable. "Enable" will display the character “DOOR1” or
“DOOR 2”. If choose “Disable”, the monitor screen will not display any characters.
INTERCOM SUB or MAIN Set:
If more than one monitor is installed, one monitor is set as “MAIN-1”. Additional monitors should be set as “SUB”.
DOOR NUM: Doorbell channel active number function
: