ECM ELEKTRONIKA PROFI Instruction Manual - page 26
ENGLISH
Instruction manual ELEKTRONIKA PROFI
25
Important!
Clean the steam nozzle and the steam dispenser after every application with a non abrasive damp
cloth; this you can remove possible liquid residues.
Risk of injury!
Avoid skin contact with the steam dispenser while cleaning!
7
CLEANING AND MAINTENANCE
A regular and accurate care is very important for the performance, the long lifetime and the safety of your machine.
Caution!
Always switch off the machine (power switch in lower position), disconnect the power cord and let the
machine cool down to ambient temperature (for at least 30 minutes) before cleaning.
7.1 General cleaning
Daily cleaning:
Filter holder, filters, water tank, drip tray, drip plate of the drip tray, measuring-spoon and tamper require daily
cleaning. Use warm water and/or with food safe detergent for cleaning.
Clean the shower and the group gasket in the lower part of the group and remove visible dirt without dissasembling
the parts.
Cleaning as necessary:
Clean the steam and hot water valve after every use.
Clean the body when the machine is switched off and cold.
Use a soft and damp cloth for cleaning.
Never use abrasive or chloric detergents!
Empty the water drip tray regularly and do not wait until it is full.
7.2 Automatic group cleaning and degreasing
Group cleaner in powder or tablet form for easy cleaning and degreasing of the brewing group is available at your
specialised dealer. The group cleaning with our tablets can be carried out every week.
The cleaning is carried out using the blind filter included in delivery:
1
Heat up the machine.
2
Put the blind filter into the filter holder.
3
Fill the blind filter with ½ sachet of group cleaning powder or insert one tablet.
4
Place the filter holder in the housing of the group.
5
Start the brewing group cleaning mode by keeping the star key pressed and pressing button 1 (espresso).
A running light appears on the control panel. Please wait until the running light has stopped and all buttons of
the control panel light up again