ECO Charge FS3 Operator/installer Manual - Charger Alarms .15
Charger Alarms
Main Switch. Urgent Alarm, shows the status of the front panel START/STOP
rocker switch.
Inlet Filter. Non-Urgent Alarm, can give warning as to when the inlet filter needs
servicing but is not enabled by default.
Low Mains. Non-Urgent Alarm, gives a indication of variation in the input mains
voltage without actually affecting the ability of the charger to provide rated output.
Can also indicate a charger module being overloaded.
Mains Fail. Urgent Alarm, a mains loss situation and the charge cannot proceed.
Non-Urgent Module Fail. Non-Urgent Alarm, there is a charger module that is
not providing output but the charger is still operating, but redundancy has been
lost.
Urgent Module Fail. Urgent Alarm, if the number of charger modules not providing
output equals or exceeds the setting for urgent module count in the monitor tab
then the charger will stop. If urgent module count is set to one then the charger is
configured without redundancy and a single fault will stop the charge.
Module Fan Fail. Non-Urgent Alarm, in the event of a complete fail of the cooling
fans the effected module will back off the maximum output current available to
level where natural convection of heat will allow the module to continue operating.
Charger Alarms .15
Charger Alarms
Main Switch
Non-Urgent Module Fail
Configuration Error
APC Communications Fail
Inlet Filter
Urgent Module Fail
Output Fuse
APC Incorrect Voltage
Low Mains
Module Fan Fail
No Output Current
APC Unknown Charger
Mains Fail
Module Over Temperature Monitor ADC Fail
Urgent Alarms. When an urgent alarm is triggered, please note the charger will
terminate its change cycle prematurely.