Ecobee SMART THERMOSTAT User Manual - page 14
List of Alerts
Below is a complete list of alerts. Depending on your
configuration, some of these may not apply to your system.
Low Battery
Furnace Air Filter
Ventilator Filter
UV Lamp
Humidifier Filter
Comms fault
Low Temp. Alert
High Temp Alert
Low Humidity Alert
High Humidity Alert
Heat Not
Responding
Cool Not
Responding
Input 1
Input 2
Maintenance
Reminder
Auxiliary Heat
Run Time
Auxiliary Outdoor
Temperature
The battery in your Smart Thermostat
will need to be changed soon.
Your furnace filter needs to be
cleaned/changed.
Your ventilator filter needs to be
cleaned/changed.
Your UV lamp needs to be changed.
Your humidifier pad needs to be
cleaned/changed.
There is no communication between the
Smart Thermostat and the Equipment
Interface module.
The temperature in the home is too low.
The temperature in the home is too high.
The humidity in the home is too low.
The Humidity in the home is too high.
The system has failed to heat the home.
The system has failed to cool the home.
Used if this input is programmed to
generate an alert.
Used if this input is programmed to
generate an alert.
You are due for regular maintenance.
Your auxiliary heat source is running
too often.
Your auxiliary heat source is running
at higher than expected outdoor
temperatures.
23 Understanding Alerts
USING yOUR
SMART THERMOSTAT
The bright, easy-to-read and easy-to-use touch screen
on your Smart Thermostat makes it simple to review and
adjust the settings any time you want.
Adjusting temperature
You can easily adjust the temperature without changing
the thermostat’s programming.
Once you’ve adjusted the temperature, the slider
changes to indicate that you are currently holding the
set temperature rather than running a program.
The Smart Thermostat will hold the new temperature
for the duration you specified in the Hold Action option
during the initial setup (see Holding Action page 11) or
until you press Resume.
If your system is set for auto-changeover mode, and you
have selected Auto in the Details System mode, an arrow
will appear on the temperature scale, in addition to the
magnifier. This will allow you to adjust both the heating
and cooling set temperatures.
There is a minimum difference allowed between the heat
set temperature and the cool set temperature. If you
change the temperatures such that this minimum is not
maintained, the system will automatically adjust the other
set temperature to compensate. You can configure the
Auto change-over mode and the minimum temperature
difference is configurable in the installer settings.
Viewing Details
The Details screen lists various temperature and equipment
details associated with your Smart Thermostat:
Current Temperature
The temperature in the room where the Smart Thermostat
is installed.
To adjust the temperature:
Use your finger to
press and move the set
temperature slider left
or right to select the
temperature you want
in the magnifier.
Tapping either end of
the temperature scale
will move the slider
by 1°F (0.5° C).
Using your Smart Thermostat
24
To access your Details:
From the Home
screen, press Details.