Ecodyne Water Systems TB-30 Installation And Operation Manual - page 13
13
OPTIONAL SETTINGS:
=
SALT EFFICIENCY
=
MAXIMUM DAYS BETWEEN REGEN-
ERATIONS
=
97% FEATURE
=
12 / 24 HOUR CLOCK
=
BACKWASH & FAST RINSE TIMES
1. To set any of these options, press and hold SELECT
for 3 seconds until “000 - -” shows in the display.
Then press (do not hold) SELECT again to display
one of the “Salt Efficiency” screens shown below.
97% FEATURE: The 97% Feature can save salt
and water by regenerating when 97% of the soften-
er’s capacity has been used up. With this feature
ON, the regeneration can occur at any time (when-
ever the system has reached 97% of its capacity).
The default is OFF. If this feature is desired, turn it
on by pressing the UP () button.
SALT EFFICIENCY: When this feature is ON, the
water softener will operate at salt efficiencies of
4000 grains of hardness per pound of salt or high-
er. The softener may recharge more often using
smaller salt dosage and less water. This softener
is shipped with the efficiency feature set OFF. Use
the UP () or DOWN (–) buttons to change
between OFF and ON. An efficiency icon will be
displayed when this feature is ON.
Controller Features / Options
FIG. 25
FIG. 26
MAXIMUM DAYS BETWEEN REGENERATIONS:
The electronic controller automatically determines
regeneration frequency. This provides the greatest
operating efficiency and, under most conditions this
feature will be left in its default mode. However,
you can set this feature to force a regeneration
every set number of days. You may want to do this
if, for exam ple, your water supply contains iron and
you want the softener to regenerate at least once
every few days to keep the resin bed clean. Use
the UP () or DOWN (–) to change the number of
days (up to 15). If no change is desired, continue
to next step.
3. Press SELECT again to display the “97%” screen.
2. Press SELECT again to display the “Recharge
Days” screen.
FIG. 27
Efficiency
Icon
FIG. 28
FIG. 29