Ecodyne Water Systems TB-30 Installation And Operation Manual - page 18
18
Troubleshooting
6. Press the SELECT button and hold in for 3 sec-
onds until the model code (tb-30) shows in the dis-
play. This code identifies the softener model. If
the wrong number shows, the softener will operate
on incorrect configuration data.
7. To change the code number - Press UP () or
DOWN (–) button until the correct code shows.
8. To return to the present time display, press the
SELECT button. If the model code was
changed, make all electronic controller set-
tings.
NOTE: If the electronic control is left in a diagnostic
display (or a flashing display when setting
times or hardness), present time automatically
returns if a button is not pressed within 4 min-
utes.
RESETTING TO FACTORY DEFAULTS:
To reset the electronic controller to its factory default
for all settings (time, hardness, etc.):
1. Press the SELECT button and hold it until the dis-
play changes twice to show “CODE” and the flash-
ing model code.
2. Press the UP () button (a few times, if necessary)
to display a flashing “SoS”.
3. Press the SELECT button, and the electronic con-
troller will restart.
4. Set the present time, hardness, etc., as described
on pages 11 & 12.
FIG. 39
FIG. 38