ECopy 3323B001 - imageFORMULA ScanFront 220e Administrator's Manual - Configuring A Data Source
eCopy Connector for Quick Connect Administrator’s Guide | 31
Configuring a data source
You can configure an existing data source or a new data source.
To configure an existing data source:
1
If the Select Recent Data Source window opens, select the data
source that you want to use and then click OK.
The Data Field Selector window opens.
2
Perform one of the following functions:
■
Map the document destination for the index fields (see
page 11).
■
Map Quick Connect index fields to database fields (see
page 27).
■
Set the default values for file name or index fields that will use
a database as the source of values (see page 29).
To configure a new data source:
1
In the New destination window, click Configure.
The Configure Data Source window opens.
2
Select the database type.
3
Specify the appropriate settings (see page 31).
4
After specifying the settings, click Test Connection.
5
When the system displays the “Successfully attached to the
database” message, click OK twice.
The Data Field Selector window opens.
6
Perform one of the following functions:
■
Map the document destination for the index fields
(see page 27).
■
Map Quick Connect index fields to database fields
(see page 29).
■
Set the default values for file name or index fields that will use
a database as the source of values (see page 31).
Quick Connect Admin Guide.book Page 31 Wednesday, March 26, 2008 3:45 PM