EcoQuest LaundryPure Owner's Manual - page 7
7
I N S t A L L A t I O N
Level and fasten the LaundryPure
mounting bracket to a wall . Attach to
wall studs using 1 1/4” screws .
0/7%2
3%26)#%
0/7%2
/54,%4
#/..%#4
).,%4
$)3#/..%#4
MOUNTING CLIP
Use the retaining screw
to secure your
LaundryPure to the
mounting bracket .
On the backside of your
LaundryPure, locate the bracket
mounting clips . Place the
LaundryPure unit on the mounting
bracket, hanging it by the clips .
1
2
3
Connect the end of the
hose from your cold water
valve to your
LaundryPure’s INLEt
connector (marked on
front of the LaundryPure) .
0/7%2
3%26)#%
0/7%2
/54,%4
#/..%#4
).,%4
$)3#/..%#4
0/7%2
3%26)#%
0/7%2
/54,%4
#/..%#4
).,%4
$)3#/..%#4
0/7%2
3%26)#%
0/7%2
/54,%4
#/..%#4
).,%4
$)3#/..%#4
finally, connect the
new hose to the cold
water inlet on your
washing machine .
Connect the
new hose
provided with your
LaundryPure to the water
OUtLEt connector on your
LaundryPure unit .
4
5
6
Be sure rubber washers are properly inserted
into hose connectors before installing hoses .
note:
this appliance must be installed in
a level, horizontal configuration as
shown .
do not install the unit
vertically or at an angle. failure to
follow these instructions may
prevent the internal moisture sensor
from operating properly .
caution:
When connecting or disconnecting
hoses, hold the threaded connector
on your LaundryPure with pliers while
turning the hose connector . failure to
follow these instructions may result in
damage to your appliance .
caution:
Hold with pliers
while installing
hose in order to
prevent fitting
from rotating.
Hold with pliers
while installing
hose in order to
prevent fitting
from rotating.