Ecoteck ILARIA Operation And Maintenance Manual - page 6
MANUAL
MANUAL
MANUAL
MANUAL
ILARIA
ILARIA
ILARIA
ILARIA
1. Acknowledgement
Dear Customer,
We wish to thank you and congratulate you on your excellent choice.
The ecoteck pellet stove ILARIA will prove how quality and economy can go hand in hand with very
high performance, reduced consumption and total practicality.
Below you will find our suggestions to ensure that you get the most out of our product and fully enjoy
all the advantages that the ILARIA pellet stove can offer.
Our aim is to offer our customers the best possible service and to provide them with the maximum
technical support.
Ecoteck srl thanks you for your trust
and wishes you many warm moments
with your new pellet stove
ILARIA
2. Safety Information
The ILARIA pellet stove must be installed and tested by specialist technical personnel who have
been trained by the manufacturer. Please carefully read this operation and maintenance manual
before installing and starting the stove!
For further explanations, please contact your ecoteck reseller.
IMPORTANT
- The stove must only be fed with high quality pellets measuring 6 mm in diameter.
- Before connecting the stove to the power supply, complete the connection of the exhaust pipes
(specifically for pellet stoves, not aluminium) to the flue.
- The protective grill placed inside the pellet hopper must never be removed.
- There must be sufficient fresh air in the room where the stove is installed.
- Never open the stove door during operation.
- When the stove is on, the surfaces, the glass, the handle and pipes heat up considerably: during
operation, these parts must only be touched using suitable protective equipment.
3. General information
The ILARIA pellet stove must only be used in residential contexts. As the stove is controlled by an
electronic board, it features completely automatic and controlled combustion; the control unit in
fact manages the ignition phase, 5 levels of heat, and shutdown, guaranteeing the safe operation
of the stove.
The combustion firepot ensures that most of the ash produced during the combustion of the pellets
falls into the ash compartment.
-5-
1. Acknowledgement
Dear Customer,
We wish to thank you and congratulate you on your excellent choice.
The ecoteck pellet stove ILARIA will prove how quality and economy can go hand in hand with very
high performance, reduced consumption and total practicality.
Below you will find our suggestions to ensure that you get the most out of our product and fully enjoy
all the advantages that the ILARIA pellet stove can offer.
Our aim is to offer our customers the best possible service and to provide them with the maximum
technical support.
Ecoteck srl thanks you for your trust
and wishes you many warm moments
with your new pellet stove
ILARIA
2. Safety Information
The ILARIA pellet stove must be installed and tested by specialist technical personnel who have
been trained by the manufacturer. Please carefully read this operation and maintenance manual
before installing and starting the stove!
For further explanations, please contact your ecoteck reseller.
IMPORTANT
- The stove must only be fed with high quality pellets measuring 6 mm in diameter.
- Before connecting the stove to the power supply, complete the connection of the exhaust pipes
(specifically for pellet stoves, not aluminium) to the flue.
- The protective grill placed inside the pellet hopper must never be removed.
- There must be sufficient fresh air in the room where the stove is installed.
- Never open the stove door during operation.
- When the stove is on, the surfaces, the glass, the handle and pipes heat up considerably: during
operation, these parts must only be touched using suitable protective equipment.
3. General information
The ILARIA pellet stove must only be used in residential contexts. As the stove is controlled by an
electronic board, it features completely automatic and controlled combustion; the control unit in
fact manages the ignition phase, 5 levels of heat, and shutdown, guaranteeing the safe operation
of the stove.
The combustion firepot ensures that most of the ash produced during the combustion of the pellets
falls into the ash compartment.
-5-
-26-
8.5. General cleaning
At the end of the season, when the stove is no longer being used, a more thorough general cleaning
is recommended.
If the previous points have been followed, this will simply involve checking the condition of the stove.
The flue gas exhaust pipe or the flue will need to be cleaned more thoroughly, and the condition
of the firepot must be checked, ordering a replacement from your reseller if required. If necessary,
lubricate the hinges on the door and the handle. Also check the ceramic fibre gasket around the
glass, on the inside of the door; if this is worn or too dry, order a replacement from your reseller.
8.6. Cleaning the glass
The glass is cleaned automatically while the stove is on by a stream of air that flows along the
surface of the glass, keeping away ash and dirt; nonetheless, after a period of a few hours, a grey
film will form on the glass, which must be cleaned after shutting down the stove.
The glass must be cleaned when the stove is cold, using a cotton cloth, kitchen paper, newspaper
and a window cleaner. At times it may be necessary to dirty the rag with the ash from the stove to
properly clean the glass, due to the abrasive nature of the ash.
N.B. If the glass is broken, do not attempt to start the stove.
-26-
The ILARIA pellet stove is a heat generator operating on solid fuel and as such must be
serviced by qualified personnel at least once a year, at the start of the season.This has
the purpose of ensuring that all the components are working perfectly.
Contact your installer/reseller to set up an annual maintenance contract.
8.5. General cleaning
At the end of the season, when the stove is no longer being used, a more thorough general cleaning
is recommended.
If the previous points have been followed, this will simply involve checking the condition of the stove.
The flue gas exhaust pipe or the flue will need to be cleaned more thoroughly, and the condition
of the firepot must be checked, ordering a replacement from your reseller if required. If necessary,
lubricate the hinges on the door and the handle. Also check the ceramic fibre gasket around the
glass, on the inside of the door; if this is worn or too dry, order a replacement from your reseller.
8.6. Cleaning the glass
The glass is cleaned automatically while the stove is on by a stream of air that flows along the
surface of the glass, keeping away ash and dirt; nonetheless, after a period of a few hours, a grey
film will form on the glass, which must be cleaned after shutting down the stove.
The glass must be cleaned when the stove is cold, using a cotton cloth, kitchen paper, newspaper
and a window cleaner. At times it may be necessary to dirty the rag with the ash from the stove to
properly clean the glass, due to the abrasive nature of the ash.
N.B. If the glass is broken, do not attempt to start the stove.
The ILARIA pellet stove is a heat generator operating on solid fuel and as such must be
serviced by qualified personnel at least once a year, at the start of the season.This has
the purpose of ensuring that all the components are working perfectly.
Contact your installer/reseller to set up an annual maintenance contract.