Ecoteck ILARIA Operation And Maintenance Manual - page 7
MANUAL
ILARIA
MANUAL
MANUAL
MANUAL
ILARIA
ILARIA
ILARIA
In any case, check the firepot daily, as not all pellets have the same high quality standard.
The glass is automatically cleaned by a flow of air; nonetheless, a slight grey film will tend to form
on the glass after a few hours of operation. As mentioned previously, the ILARIA pellet stove must
be fed with pellets with a diameter of 6 mm, however it can also be made to operate with pellets of
different diameters; contact your ecoteck reseller for further details.
3.1. Liability
By providing this manual, ecoteck declines all liability, both civil and penal, for any accidents deriving
from the failure to observe the instructions contained herein, in part or in full.
Ecoteck declines all liability due to the improper use of the stove, incorrect operation by the user,
unauthorised modifications and/or repairs, and the use of non-original spare parts for this model.
The manufacturer declines all direct or indirect civil or penal liability due to:
-poor maintenance
-failure to observe the instructions contained in the manual
-operation not compliant with the safety directives
-installation not compliant with the national standards in force
-installation by unqualified and untrained personnel
-modifications and repairs not authorised by the manufacturer
-use of non-original spare parts
-extraordinary events
3.2. Spare parts
Only use original spare parts.
Never wait for the components to be completely worn out before replacing them.
Replace a worn component before it is completely broken, so as to prevent any accidents due to the
sudden breakage of the components that may cause serious damage to people or things.
Perform the periodical maintenance checks, as described in chapter 8.2.
3.3. What are pellets wood?
Wood pellets are made from sawdust and shavings of wood products produced in sawmills. The
material used must not contain any other substances, for example glue, lacquer or synthetic sub-
stances. Subjected to high pressure, the wood is pressed through a die with holes; due to the high
pressure, the sawdust heats up and the natural gums in the wood are activated. In this way, the
pellets hold their shape even without the addition of adhesives. The density of wood pellets varies
according to type of wood used, and may exceed 1.5 - 2 times the density of natural wood.
-6-
In any case, check the firepot daily, as not all pellets have the same high quality standard.
The glass is automatically cleaned by a flow of air; nonetheless, a slight grey film will tend to form
on the glass after a few hours of operation. As mentioned previously, the ILARIA pellet stove must
be fed with pellets with a diameter of 6 mm, however it can also be made to operate with pellets of
different diameters; contact your ecoteck reseller for further details.
3.1. Liability
By providing this manual, ecoteck declines all liability, both civil and penal, for any accidents deriving
from the failure to observe the instructions contained herein, in part or in full.
Ecoteck declines all liability due to the improper use of the stove, incorrect operation by the user,
unauthorised modifications and/or repairs, and the use of non-original spare parts for this model.
The manufacturer declines all direct or indirect civil or penal liability due to:
-poor maintenance
-failure to observe the instructions contained in the manual
-operation not compliant with the safety directives
-installation not compliant with the national standards in force
-installation by unqualified and untrained personnel
-modifications and repairs not authorised by the manufacturer
-use of non-original spare parts
-extraordinary events
3.2. Spare parts
Only use original spare parts.
Never wait for the components to be completely worn out before replacing them.
Replace a worn component before it is completely broken, so as to prevent any accidents due to the
sudden breakage of the components that may cause serious damage to people or things.
Perform the periodical maintenance checks, as described in chapter 8.2.
3.3. What are pellets wood?
Wood pellets are made from sawdust and shavings of wood products produced in sawmills. The
material used must not contain any other substances, for example glue, lacquer or synthetic sub-
stances. Subjected to high pressure, the wood is pressed through a die with holes; due to the high
pressure, the sawdust heats up and the natural gums in the wood are activated. In this way, the
pellets hold their shape even without the addition of adhesives. The density of wood pellets varies
according to type of wood used, and may exceed 1.5 - 2 times the density of natural wood.
-6-
-25-
-25-
8.4. Quarterly cleaning
PLATE POSITION
VACUUM INSIDE
UNSCREW THE PLATE
display
Lift the glass panels
ceramic glass
ash compartment
clenaning stopper
8.4. Quarterly cleaning
PLATE POSITION
VACUUM INSIDE
UNSCREW THE PLATE
display
Lift the glass panels
ceramic glass
ash compartment
clenaning stopper