Ecotop Schleicher Ka-8b Instruction Manual - Patin De Queue
Notice Ecotop - Page 19 - Ka-8b 1:4
7) Ajustez la longueur de la commande et connectez-la au
palonnier du servo de profondeur.
Adjust the length of the linkage and connect it to the elevator
servo arm.
F8
F7
PATIN DE QUEUE
TAIL SKID ASSEMBLY
PIECES FUSELAGE
(F7) Trappe commande de profondeur .....................................1
(F8) Patin de queue ..........................................................................1
FUSELAGE PARTS
(F7) Elevator hatch ..........................................................................1
(F8)Tail skid........................................................................................1
PIECES COMMANDE DE DIRECTION
(5) Servo de direction et ses accessoires .................................1
(G1) Câble en acier tressé ..............................................................1
(D4) Chape métal M2,5 ................................................................... 4
(D5) Ecrou M2,5 ................................................................................ 4
(D10) Embout de chape pour câble ............................................ 4
(D13) Tube à sertir ........................................................................... 4
RUDDER LINKAGE PARTS
(5) Rudder servo and accessories ...............................................1
(G1) Braided steel cable ..................................................................1
(D4) Steel clevis M2.5 ..................................................................... 4
(D5) Nut M2.5 .................................................................................... 4
(D10) Clevis coupler for steel cable .......................................... 4
(D13) Crimp tube............................................................................... 4
1) Coupez l'entoilage sur le plan de pose du patin de queue.
Cut the covering on the glueing surface for the tail skid.
2) Collez le patin à l'époxy. Collez la trappe soit avec deux
points de cyano, soit avec un ruban adhésif.
Secure the tail skid using epoxy. The hatch is just glued with
two drops of CA, or using adhesive tape.
MONTAGE DE LA COMMANDE DE DIRECTION
RUDDER LINKAGE ASSEMBLY
5
G1
D10
D13
D5
D4