Ecotop Schleicher Ka-8b Instruction Manual - Montage De La Verriere
Notice Ecotop - Page 24 - Ka-8b 1:4
1) Montez les pales sur le porte-pales à l'aide des axes.
Verrouillez les axes avec les circlips.
Install the blades on the hub with the spindle. Secure the
spindles with the retaining rings.
2) Le porte-pales se fixe sur l'axe moteur à l'aide des vis de
pression. Sur un côté, l'axe moteur possède un méplat. Une
des vis de pression doit être vissée sur ce méplat.
The hub is secured on the motor shaft using socket set screws.
On one side, the motor shaft is fitted with a flat surface. One
socket set screw must be tightened on the flat surface.
MONTAGE DE LA VERRIERE
CANOPY ASSEMBLY
PIECES DE LA VERRIERE
(F4) Verrière .......................................................................................1
(C3) Charnière plate........................................................................ 2
(D8) Vis à bois 2 x 5 mm ................................................................ 6
(V1) Support de verrou .................................................................1
(V2) Tige de verrou .........................................................................1
(V3) Ressort .......................................................................................1
(V4) Tirette ........................................................................................1
(V5) Boule ...........................................................................................1
CANOPY PARTS
(F4) Canopy .........................................................................................1
(C3) Pinned hinge ............................................................................ 2
(D8) Self tapping screw 2 x 5 mm ............................................. 6
(V1) Latch case .................................................................................1
(V2) Latch spindle ...........................................................................1
(V3) Spring .........................................................................................1
(V4) Lever ...........................................................................................1
(V5) Ball ..............................................................................................1
F4
C3
D8
V5
V2
V3
V4
V1
1) Vissez les charnières sur le cadre de la verrière avec une vis
au centre.
Attach the hinges on the canopy frame with one screw in the
center hole.
2) Vissez les charnières sur le cadre de fuselage avec deux vis
dans les trous extérieurs.
Attach the hinges on the fuse frame with two screws inside the
outer holes.