ECR International Enviroair Installation, operation and maintenance manual - page 9
Ensure unit is plugged and power is available.
1. Press the MODE button to select COOL,
HEAT (Cooling & Heating models only), or
FAN mode.
2.
Push the TEMP button to set the
desired temperature within a range of
O
O
62 F ~ 86 F.
3.
Push the FAN SPEED to select the FAN
mode of AUTO, HIGH,MED or LOW.
4. Press the ON/OFF button to start the air
conditioner. The OPERATION indicator
on the display panel of the indoor unit
illuminates.
Push the ON/OFF button
again to stop this unit operation.
Ensure unit is plugged and power is available.
The OPERATION indicator on the display
panel of the indoor unit starts flashing.
1. Push the MODE button to select DRY.
2. Push the TEMP button to set the
desired temperature within a range of
O
O
62 F ~ 86 F.
3. Push the ON/OFF button, the OPERATION
lamp lights and the air conditioner starts
to operate in DRY mode at LOW fan
speed. Push the ON/OFF button again to
stop this unit operation.
Note:
The fan speed cannot be adjusted
when the unit is in AUTO and DRY mode.
7
3
2
1
4
2
1
3
COOL/HEAT/FAN operation
DRY operation
The FAN mode can not be used to
control the temperature. While in this
mode, only steps 1
3 and 4 may be
performed.
NOTE
TEMP
AUTO
COOL
DRY
HEAT
FAN
HIGH
MED
LOW
MODE
FAN SPEED
TIMER ON
ECONOMY
ON/OFF
TIMER OFF
FOLLOW
ME
RESET LOCK
SET TEMPERATURE( F)
SWING
LED
DISPLAY
TURBO
O
TEMP
AUTO
COOL
DRY
HEAT
FAN
HIGH
MED
LOW
MODE
FAN SPEED
TIMER ON
ECONOMY
ON/OFF
TIMER OFF
FOLLOW
ME
RESET LOCK
SET TEMPERATURE( F)
SWING
LED
DISPLAY
TURBO
O