EMotimo spectrum ST4 Instructions Manual - page 9
eMotimo spectrum Instructions B003
- Copyright © 2016 eMotimo LLC
9
Presets – GoTo Positions:
There are four GoTo presets you can program. To set, scroll over to the GoTo positions
pages. Do this from the main menu by selecting the top menu (
Live Motion
) and then
pressing the right DPad button or right on the Navagation joystick until you see the GoTo
frames headers. The first heading you will see is the GoTo Presets: Square. By moving
right on the Dpad or right on the Navigation switch you will find the next GoTo preset,
which is GoTo Presets: Circle. Keep scrolling right to program all four presets.
Programming a preset:
1. Target: Set your target parameter by moving all 4 axis to a position you want to
lock in as a preset. Press X to lock in this position.
2. Time: Once Time is highlighted, scroll up and down to program the amount of
time/duration you want your move to take to arrive at your target position.
3. Ramp: Program the acceleration and deceleration in seconds at the start and end
of your move to the target position. Ramp is included in the overall duration of the
shot. In other words, ramp time is not added to the overall time of the shot.
4. Clear: Press X twice to clear your target position.
Once a preset is programed, you can move the head around freely. When you hit the
preset button, the head will drive all 4 axis to the preset (GoTo target position) with the
qualities you programed in to that preset.