EMotimo TB3 Black Instructions For Use Manual - page 12
eMotimo TB3 Instructions for Use 108- Copyright © 2013 eMotimo LLC
12
Rev 3-point move:
A rev 3-point move means you are setting up a shot that moves through 3 points,
where you set your end point first, your through point second, and your start point
third. Some prefer this option to save on power when setting up long sliding
moves on a dolly.
DF slave mode:
With DF slave mode you can program your TB3 using the Dragonframe software.
To do this, you first plug in your TB3 to your computer using the USB port. This
will power on your TB3. You must also plug in the AC adapter, or 12V power
source or the motors will not move. Once your TB3 is on and powered, select
“DF slave mode” by scrolling down in the starting menu to “DF slave mode”.
Press “C” to continue. On your computer, open up the Dragonframe software and
configure the ArcMoco connection.
Important notes/resources:
• More information on connecting to Dragonframe can be found on our forum-
http://www.emotimo.com/forum/viewtopic.php?f=10&t=198
• The TB3 LCD and joystick are not active while being used in this mode.
• Occasionally, on the MAC OS, when connecting to ArcMoCo #1 in
Dragonframe, the TB3 will automatically restart. If you notice this happen,
don’t unplug your TB3 or shut down the Dragonframe software. Using the
joystick, set the TB3 back to DF slave mode to continue.