EMotimo TB3 Black Instructions For Use Manual - page 9
eMotimo TB3 Instructions for Use 108- Copyright © 2013 eMotimo LLC
9
time at the start of your shot and 2 seconds of stationary time at the end of your
shot.
Review screen/Start delay/Program running:
Review your settings and press “C” to immediately start your program. If you
would like to add a start delay to your shot you can do so as well on this screen.
Start delay allows you to start your shot after a specified amount of time. Jog the
joystick up and down to set Start delay. Once you have selected your Start delay,
press “C” to start your program.
In program, the LCD will give you feedback on where it is in the Shoot. It will
update once every shot with:
Upper Left: Current Shot/Total Shots
Upper Right: Program Stage (LeadIn, RampUp, Linear, RampDn,
LeadOT)
Lower Left: Time Remaining in HH:MM:SS
Lower Right: Source Voltage
Repeat – C Reverse - Z:
Once your program is complete you will be prompted to either repeat or reverse
it. If you repeat the program, then your next program will be the exact same. To
repeat the program, press “C”. If you reverse the program, then your next
program will be your previous program shot in reverse order. To reverse the
program, press “Z”.