EMotimo TB3 Black Instructions For Use Manual - page 13
eMotimo TB3 Instructions for Use 108- Copyright © 2013 eMotimo LLC
13
Setup Menu:
In the setup menu, you can choose from general settings for your TB3. To
access the setup menu, scroll down in the starting menu to “Setup Menu”. Press
“C” to continue.
Aux Motor: On/Off:
If you are using a 3rd motor (typically for a dolly), you will need to make sure the
Aux Motor is turned on. Scroll up or down to switch between on and off. Press
“C” to select.
Pause:
By “Enabling” the pause button, you can pause the TB3 during a sequence.
Scroll up and down to change between “enabled” and “disabled”. Press “C” to
select. If pause is enabled, press “C” and “Z” at the same time to pause the TB3
during a shot.
PT Motors on:
How your TB3 manages power for your pan and tilt motors.
Shoot (Pwr Save):
This means power down at all times except for the move - This saves a lot of
power for many types of shots, but could be less precise for long lens shots -
This is a great mode if you are really trying to extend your times. Run times can
be increased several fold with this mode!
Shoot (accuracy):
Recommended
This means power down when static time (shutter) not engaged - Good for most
PT settings.
Program:
This means power down only at the end of a sequence, but on during the rest of
the time. Should rarely/if ever be used for the Pan Tilt motors.
Always:
This means no power down, even after a shot sequence completes- uses the
most power and should only be used on AC (mains)
Aux Motors on:
How your TB3 manages power for your Aux motor.
Shoot (Pwr Save):
Recommended (level/flat shots)
This means power down at all times except for the move - This saves a lot of
power for many types of shots, but could be less precise for long lens shots -
This is a great mode if you are really trying to extend your times. Run times can
be increased several fold with this mode!