Ezon SHS-7020 User manual - page 22

20

Registering the User Password (Code 20)

The user password can be 4~12 digits. Up to 250 codes can be registered, including 

the card registration.

1. Entering the Code in the Program Mode

When the LED numbers 1, 2 and 3 flash after 

the program mode is run, press the code 20 

and then the [¿] button.

2. Entering the User Code

When the LED numbers 4, 5 and 6 flash, press 

the user code (1~250) and then the [¿] button.

- Valid Entry: The 

‘toot, toot’ sound is activated, and 

the mode is turned into the password entry 

standby mode. 

- Invalid Entry: The 

‘toot~~ toot, toot’ sound is 

activated, and the mode is turned into the program 

code entry standby mode.

3. Entering the User Password

When the LED 7, 8 and 9 flash, enter the user 

password and then the [¿] button.

- Entered password is displayed on the keypad in 

the same order and saved. The unit then turns into 

the user code standby mode. 

- It is recommended to use the password of at least 

6 digits for the security reason (use of 0~9 

numeric codes).

Valid Entry: "Too~~t, toot, toot

” 

Failed: "Toot~~, toot, toot" 

Toot, toot 

Toot, toot