Ezon SHS-7020 User manual - page 28
26
Entrance Control Setup (Code 60~63)
The entrance control can be set up or released to the registered user codes individually
or in a group.
1. Entering the Code in the program mode
When the LED numbers 1, 2 and 3 flash after
the program mode is run, press one of the
following codes and then press the [¿] button.
- Entrance control release by individual user: 60
- Entrance control setup by individual user: 61
- Entrance control release by group: 62
- Entrance control setup by group: 63
2. Entering the User Code or Group Code
When the LED numbers 4, 5 and 6 flash, enter
the user code or group code and then press
the [¿] button.
- 60~61 entered in step 1
: Enter the user code
- 62~63 entered in step 1
: Enter the group code
- In case of entrance control release (code 60 or 62),
step 2 completes the process.
3. Setting up the Entrance Control Start Time/End Time
When the LED numbers 7, 8 and 9 flash, enter
the entrance control start time and end time in
that order and then press the [¿] button.
Ex) Entrance control start time: 10:00 PM
Entrance control end time: 08:30 AM
=> Code Entry: 22000830
Success: "Too~~t"
Failure: "Toot~"
Success: "Too~~t"
Failure: "Toot~"
Success: "Too~~t"
Failure: "Toot~"