Ezy Gym Fit 100 User Manual - page 10
10 - Maintenance
1. Cleaning:
The treadmill should be kept clean, preferably with a cover over the belt & motor cover.
Pull the plug out first before cleaning.
Clean it every one to two months. When cleaning, open the cover, clean the dust from motor and
sensor and then check if the screws are loose.
If not used for a while make sure you clean the machine prior to use and run machine by itself to
ensure that dust or foreign objects (insects) have not upset the sensor causing over speeding.
2. Shoes:
Shoes should be soft and clean when running.
11 – Running Belt Adjustment
The belt will stretch after time, necessitating adjustment. This is a normal function of the treadmill.
Belt tightness is determined by both the user’s weight
and speed combination. Only adjust the belt to suit the primary user‘s
weight at their normal usage speed – casual user’s differing weight and speed preference may cause the belt to slip.
WARNING - OVERTIGHTENING THE BELT WILL CAUSE DAMAGE TO THE BELT AND MOTOR!
Figure 1
Figure 2
Figure 3
The belt tension adjustment bolts are located on the center of each end cap as shown above.
1. Running belt has shifted to the left side. (Figure 1 - Adjusting the belt to right side)
Keep the speed of belt at 3km.
1/4 turn the Left Rear Roller Adjustment Bolt to the clockwise direction.
Operating the running belt for a few minutes, check the movement of belt.
Try to adjust until the running belt is centered.
2. Running belt has shifted to the right side. (Figure 2 - Adjusting the belt to the left side)
Keep the speed of belt at 3km.
1/4 turn the Left Rear Roller Adjustment Bolt to the count-clockwise direction.
Operating the running belt for a few minutes, check the movement of belt.
Try to adjust until the running belt is centered.
3. Running belt is slipping during use (Figure 3)
Keep the speed of belt at less 3km.
1/4 turn the both Rear Roller Adjustment Bolt to the clockwise direction.
Check the belt tension if the running belt is still slipping.