Ezy Gym Fit 100 User Manual - page 7
5 – Assembly
6 - Adjusting and testing
1. Put safety key onto Control Panel.
2. Please check the running belt moves smoothly and with no noise.
3. Plug in & turn on power outlet: Control panel should display “0” & the running belt is still.
4. Press the “on/off” button, the treadmill should start running with a low speed (1.0km/h).
5. Press the “fast” & “slow” buttons to check the speed controls.
6. Press the “on/off” button again, treadmill will stop, pull out the power plug.
7. Adjust the tilt of the Platform by pulling the Manual Incline Adjustor down from the Backplate.
1. Insert left and right column tubes into bottom
frame, fix with allan screws.
2. Screw Control Panel onto handlebar, connect
signal cable and fix cable.
3. Fixed handlebars to the columns with allan
screws.
4. Fold the treadmill, then press one end of the
spring onto ball head.