Factory Cat 29 Operator's Manual & Service Book - Cylindrical
To release hopper, twist handle clockwise,
then pull
1
2
CYLINDRICAL
BRUSH
SYSTEM
The Optional Cylindrical Brush System
sweeps and scrubs simultaneously. The
"C.B.S." brush head replaces the disk brush
system. It includes one motor, two cylindrical
brushes, and a dirt hopper.
OPERATION:
The Cylindrical Brush Head operates like our
conventional disk brush head. Pushing down
on the front edge of the brush pressure button
raises pressure. Pushing down on the back
lowers pressure, and will eventually raise the
brushhead off the floor.
Too much pressure can cause the system to
shut down automatically because of overload.
In this case, back off on the pressure. Use the
gauge as a relative indicator.
The brushes can only turn when you step on
the foot pedal. It is important that you make
sure the machine is always moving when the
brushes run.
Brushes and soap solution flow will both stop
when the machine stops.
You should periodically empty the dirt hopper
and clean it out. To do this, open the righthand
door, and twist the handle in the hopper until
the back of the hopper moves toward the rear
of the machine. Then slide the hopper out of
the machine.
Clean the hopper at the end of the machine's
work cycle--whether or not it is full. Wash it out
carefully. If you let dirt harden inside it will be
much harder to clean out next time.
Page 15
To access dirt hopper open lefthand front
door of machine. Hopper is behind brush
system.
Hopper