Factory Cat 29 Operator's Manual & Service Book - page 5
SAFETY WARNINGS! (Continued)
11.
BEFORE WORKING ON THE MACHINE, TURN THE KEY OFF, REMOVE KEY,
AND DISCONNECT THE BATTERY.
Be aware that the brush and vacuum motor can
start if someone else pushes on the handlebar control while the key is turned on, even
though the machine makes no noise, and appears "off". Do not work on machine while
someone else is sitting in operator's seat. They could accidentally turn on the power
while you work.
12.
ALWAYS UNPLUG CENTRAL COMMAND FROM BATTERIES BEFORE USING
AN EXTERNAL CHARGER.
A power surge from a "dumb" charger could damage Central
Command's electronics. This could destroy Central Command's ability to control traction motor
speed, and could lead to a "runaway" machine. We do not recommend the use of a "dumb"
(non-electronic) charger! If you must use one, you must be sure the battery back is discon-
nected from the Central Command module before connecting the charger.
13.
STOPPING: UNDERSTAND THE DYNAMIC BRAKING SYSTEM BEFORE YOU
OPERATE THE MACHINE ON SLICK RAMPS.
Machine does not coast. Releas-
ing handlebar control automatically applies braking force. You control the amount of
braking by the suddenness (or smoothness) with which you release the bail.
14.
PARKING: WE DO NOT RECOMMEND PARKING MACHINE ON RAMPS OR
SLOPES.
15.
TO AVOID TIPOVER, DO NOT MAKE TIGHT TURNS SIDEWAYS ON A RAMP.
TURN AROUND ON FLAT GROUND OR FLOOR ONLY. DO NOT MAKE SHARP
TURNS AT HIGH SPEED.
16.
WHILE WORKING ON MACHINES EQUIPPED WITH THE THE AUTOMATIC
SQUEEGEE LIFT SYSTEM, BE SURE KEY IS REMOVED FROM KEYSWITCH.
Inadvertent operation by another person of the squeegee lift mechanism while
hands or fingers are in the way could pinch.
17.
DO NOT OPERATE THE MACHINE IF ANY PARTS HAVE BEEN REMOVED
FROM IT.
Do not remove or paint over Warning decals. If Warning decals are damaged,
they must be replaced.
18.
AUTHORIZED , TRAINED OPERATORS ONLY.
This machine should only be operated
by a trained operator. As part of his training, he/she must read this manual thoroughly. If
extra copies are needed, contact your local dealer, or the Factory directly at 1-800-634-
4060.
19.
DO NOT OPERATE MACHINE IF IT IS IN UNSAFE CONDITION.
If the machine is in need of repair or is in any way unsafe or contributes to an unsafe
condition, the matter should be reported immediately to the shift supervisor. Do not
operate the machine until it is returned to proper operating condition.
PAGE 3