Fairbanks 27707 Operator's Manual - page 10
09/07
9
51164 Rev. 1
Section 2: Installation
Unpacking and Setup
1. Remove the scale from the packing box.
2. On the bottom-side of the scale, move the
switch to the appropriate setting.
−
lb (
Pounds
) is used for Standard English
Weighments.
−
kg (
Kilogram
) is used for Metric
Weighments.
−
BT (
Bidirectional
Telecommunications
) is used for
relaying the weighment from the scale to
the computer to the professional office.
3. Place the scale on a flat surface where it will be used.
4. If the scale is used for
Stand Alone
operations, and not needing computer
access, it is now ready for use.
NOTE: For
Stand Alone
operations, the Mode switch will be in the
lb
or
kg
position.
5. If the scale needs computer access, with the computer powered down, plug the
RS232 (DB9) cable into the computer port, then re-start the computer. The
weights may be viewed by enabling the Serial port with HyperTerminal or
software which is available from Fairbanks.
NOTE: For computer access or
BT
operations, the Mode switch
must be in the
BT
position.