Fairbanks 27707 Operator's Manual - page 12
Section 3: Operations
09/07
11
51164 Rev. 1
Modes of Operation
The two basic modes of operation are Stand Alone Weighing Operations, and
Weighing with Bidirectional Telecommunications.
Stand Alone Weighing Operations
Stand Alone Weighing Operations occur when the Mode switch is in the lb or kg
position. It will also occur if the BT position is selected and the RS232 device does
not communicate with the scale
1. On the bottom-side of the scale, move the switch to the one of these settings.
▪
lb (
Pounds
) is used for Avoirdupois Weighments.
▪
kg (
Kilogram
) is used for Metric
Weighments.
2. Once the switch is selected, place the scale on
a flat surface where it will be used.
3. Stand on the scale to momentarily to activate
the scale and its display.
4. After its warm-up test, the scale should
display zero (0.0)
5. Stand on the scale to obtain the weight.
6. Once the weight is stable, the scale will beep twice (2) indicating the weight
has been captured
7. Step off the scale. The displayed weight is held on the display for about ten
(10) seconds.
8. After the ten (10) seconds, the scale will briefly try to re-zero itself for the next
weighment, provided there is less than ten (10) pounds on scale.
9. If a new weighment is not detected, the scale will automatically turn off after
30
second
s and the weighing process is complete..