Fantec MR-35DRN User Manual - page 10
Note:
Administrator
2.8.3 Virtual Server
2.8.4 ALG
2.8.5 Access Control
These 3 functions below is only suitable for professional
.
2.9 Maintenance
2.9.1 Disk Utility
Six sections are included in Maintenance. There are “Disk Utility”, “RAID
Setting”,“Firmware Upgrade”, “Save Configuration”, “Restore Configuration” and
“Factory Reset”.
Disk utility shows device name, type of file system, total disk size, used disk size,
volume mounted, and disk mount status of all disks.
For new attached hard disk, you should format the HDD before any setting.
To avoid pressing the button by mistake, the system will acquire your confirmation
before starting “Format” or “Scandisk” function.
The format and scan procedure will take a few moments.Please be patient until
the progress has finished.
Encrypt Box
Format Button
Scan Button
Detail Button
Refresh button
Disk spin down time
2.9.2 RAID Setting
Rebuild button
The MR-35DRN supports 128 bits loop-AES encryption of EXT2 file system. If you
want to turn on this function, you should input 20 characters password and format
disk again. (If a RAID is used, this function is disabled)
This is used to format the specified disk. The device supports three types of file
system: “EXT2”, “EXT3” and “FAT32”. (If a RAID is used, this function is disabled)
This is used to check the disk integrity. (If a RAID is used, this function is
disabled)
If the hard disk supports S.M.A.R.T, it will report the disk health status.
This is used to refresh hard driver status.
Specify your disk spin down time if no access to the hard disks.
The MR-35DRN supports RAID mode 0, 1 and Linear. You only have to plug in 2
hard disks and the RAID function can be used. To create the RAID system please
format the hard disks and select EXT2 or EXT3 file system and RAID 0, 1 or
Linear RAID mode.
This is used to rebuild raid file system after replacement of a broken hard disk.
16
17
2.8.2 Bonjour
THE MR-35DRN supports Apple Bonjour protocol and Apple iTunes server.
Check Enable box could enable Bonjour protocol.
Check iTunes Enable box could enable iTunes server.
All MP3 music files should be storedt in “/public/music” folder through samba or
ftp protocol, then client PC can search “fantec_Music_Box” with iTunes and play
music. The iTunes software can be downloaded from Apple.com website.