Fantic Caballero 125 series Owner's Manual - page 64

64

off (figure O). You can modify in sequence the 

hours and then the minutes based on the se-

lected data (which will be shown flashing with 

f=1Hz, Duty=50%). 

Clock adjustment (fig. O)

Briefly press the button to increase the selected 

parameter by one unit. Press and hold the button 

to change from setting the hours to setting the 

minutes, followed by exiting setting. The Time 

parameter will be shown in the format 0-24 if 

the selected unit of measure is km/h.It will be 

shown in the format 0-12 if the selected unit of 

measure is mph. In this case, during setting, dig-

its 10 and 11 will show the message AM or digits 

11 and 12 will show PM as shown in figure P.

Setting the clock in the 0-12 format 0-12 (fig. P)

While in the setup menu, the clock is NOT up-

dated.

Once you have entered the setting menu:

-   if no button is pressed for 20 seconds, or 

-   if the vehicle begins moving (vel>0), or

-   (for models without vehicle battery) if the 

vehicle is turned off, or

-   (for models with vehicle battery) if the 

key selector is turned to OFF; the system 

will automatically go into standard operat-

ing mode, and any modifications will be 

saved. 

MODIFICATION OF THE UNIT OF MEASURE

If you press the button to change the unit of 

measure, only the symbols km/h and mph will 

remain displayed. The selected unit will flash 

(con f=1Hz, Duty=50%) (fig. Q).

Press the button briefly to change the selected 

unit. Press it and hold it to go back to the screens 

in fig. N.

km/h

mph

Clock adjustment, modification of units of meas-

ure, and exit from the setup menu (fig. N).

Press the button for the function that you want 

to modify or at the “OUT” screen to exit the setup 

menu.

SETTING THE CLOCK

If you press the button to set the clock, only those 

segments related to this function will remain ac-

tive, whereas the other segments will be turned