FAR KJ 60 Original Instructions Manual - page 10
GB
KJ 60
10
Date 10-2013
Revisione - 19
TOOL IDENTIFICATION
The riveting tool
KJ 60
is identified from a marking that shows
company name and address of manufacturer, designation of
the tool, CE mark and year of manufacturing. If any service
is requested, please make reference to the data shown on
the marking.
GENERAL NOTES AND USE
The tool can be employed only for threaded inserts with thread
of
M3
÷
M8
diameter.
The
KJ 60
oil pneumatic system assures more power than
the pneumatic system used for other models. That means
a reduction in the problems due to the wear and tear of the
components, therefore, there will be an increase in reliability.
The technicai solutions adopted reduce the dimensions and the
weight of the tooi which, for these reasons, make it very handy.
The possibilities of leakage from the oil-dynamic system, are
eliminated by some sealed gaskets, which solve this problem.
TECHNICAL DATA
• Working pressure ......................................................
6 BAR
• Min. int. diam. of the compressed air
feeding hose .......................................
min. diam = 8 mm
• Air consumption per cycle ............................................
9
Nl
• Max power .................................................
6 BAR -13656 N
• Weight ..................................................................
2,200 Kg
• Working temperature ...........................................
-5°/+50°C
• Root mean square in total acceleration frequency (Ac)
to which the arms are subjected. .........................
m/s
2
• A-weighted emission sound pressure level .............
70 dBA
• Peak C-weighted instantaneous sound pressure
• A-weighted emission sound pressure .....................
88 dBA
MAIN COMPONENTS
A)
.................................................................Threaded tie rod
B)
...................................................................................Head
C)
..................................................... Ring nut clamping head
D)
...............................................Tensile strength pushbutton
E)
.....................................................Unscrewing pushbutton
F)
................................ Insertion Pin Hole Dechucking clutch
G)
..................................................Regulation stroke ring nut
H)
........................................................... Balancer connection
I)
..................................................................
Pneumatic motor
L)
.......................................................................Oil tank plug
M)
.............................................. Compressed air connection
N)
...............................................................Protection bottom
KJ 60
KJ 60
80
Ø 35
295
288
Ø109
Ø 24
KJ 60
L
F
E
A
B
C
M
D
G
H I
N
AIR FEED
The air feed must be free from foreign bodies and humidity in
order to protect the tool from premature wear and tear
of the components in movement, therefore we suggest to use
a lubrificator group for compressed air.
Company name and
address
Designation of the tool
Year of manufacturing