Farm King 500 Operator And Parts Manual - Discharge Spout
Assembly - 500, 600, 660
25
Figure 8
Attach the top brackets of the hitch arms by bolting
a 1” x 2-1/4” spacer (Item 1) [Figure 8] between the
top brackets with a 3/4” x 4” bolt (Item 2) [Figure
8] and lock nut. Use the bottom front holes on the
brackets.
Attach the hitch top bar (Item 3) [Figure 8] between
the top brackets by bolting the welded tube on
the top bar between the top brackets with a 3/4”
x 4” bolt (Item 4) [Figure 8] and lock nut. Use the
bottom rear holes on the brackets.
Bolt the opposite end of the hitch top bar to the
top of the main frame with a 1/2” x 1-3/4” hex bolt
(Item 5) [Figure 8] and 1/2” lock nut. Use the same
hole position as the hitch tubes.
Tighten all hardware.
Attach a Category 1 top link pin (Item 6) [Figure 8]
to the top holes of the top brackets.
The Category 1 pin is used for a standard three-
point hitch only. The bushing in the lower hole is
used for the Quick Hitch.
1
2
3
4
5
6
6
Discharge Spout
Figure 9
Align the discharge spout (Item 1) [Figure 9] on the
main frame mount. Place the four spacers (Item
2) [Figure 9] and spout clamps (Item 3) [Figure 9]
around the spout ring on the mounts.
Lubricate the spout ring and spout clamps using
multipurpose lithium based grease.
Attach the spacers and clamps to the mounts using
eight 3/8” x 1-1/2” bolts (Item 4) [Figure 9], sixteen
washers (Item 5) [Figure 9], and eight lock nuts
Align the spout deflector adjustment rod (Item 7)
[Figure 9] on the mounts. Attach using two 1/2” x
1-1/2” clevis pins (Item 8) [Figure 9] and hair pins.
4
1
5
3
2
5
6
8
7
8