Farm King 500 Operator And Parts Manual - Important
Maintenance - 500, 600, 660
48
Safety Sign (Decal) Installation
IMPORTANT
When replacing safety signs (decals), the
temperature must be above 10° C (50° F).
• Remove all portions of the damaged safety sign
(decal).
• Thoroughly clean the area with adhesive remover
and glass cleaner. Remove all adhesive residue.
• Allow the area to dry completely before installing the
new safety sign (decal).
• Position the safety sign (decal) in the correct location.
• Remove a small portion of the backing paper on the
safety sign (decal).
• Press on the safety sign (decal) where the backing
paper has been removed.
• Slowly remove the remaining backing paper,
pressing on the safety sign (decal) as the backing
paper is removed.
• Using the backing paper, pressing firmly, move the
backing paper over the entire safety sign (decal) area.
Note: Small air pockets can be pierced with a pin
and smoothed out using the piece of the
backing paper.
Chains And Fasteners
Periodically check all bolts and fasteners for
tightness.
Figure 25
Check the main fan bolt (Item 1) [Figure 25] for
tightness.
Check the tension in the drive chain (Item 2) [Figure
25]. Slack on the lower side of the chain should be
3/8” to 1/2”.
Check the shear bolts on the PTO driveline.
500 models – 1/4” x 1-3/4” GR5
600/660 models – 5/16” x 1-3/4” GR5
Shear bolts should be fastened with a lock nut or
two jam nuts. These bolts must be kept tight to
prevent wear of the bolt and bolt holes.
2
1