Farm King 500 Operator And Parts Manual - page 28
Assembly - 500, 600, 660
26
Hand Crank Chute Control
Figure 10
Bolt the crank mounting bracket (Item 1) [Figure
10] to the top hitch bar using a 3/8” x 1-1/4” hex
bolt, lock washer and hex nut.
Insert the crank handle through the crank mount
bracket (Item 1) [Figure 10] and through the bracket
welded to the main frame (Item 2) [Figure 10].
Secure the crank handle to the bracket on the main
frame using a washer and roll pin on each side of
the bracket.
2
1
Figure 11
Thread the cable through the hole (Item 1) [Figure
11] in the crank handle to even lengths. Wrap each
end of the cable around the handle four times, to
each side of the hole in opposite directions.
Figure 12
With the discharge spout turned forward, fasten
the two ends of the cable to the bracket welded on
the other side of the discharge spout using a 1/4”
cable clamp (Item 1) [Figure 12].
1
1