Faroudja DVP3000 Installation And Operation Manual - page 8
7
Note: It is necessary to identify which signal
format and refresh rate is being used in order to
synchronize the output. If the scan rate being
used is not listed, try each of the offered rates
until an image appears.
Pass-Through V Rate
60Hz
75Hz
85Hz
Note: If the HDTV Format is selected, the V-Rate
selection is not available.
OSD Status
On (Default)
Off
OSD Position
0-255
Note: 0 is top of the screen
RS232 Baud rate
4800
9600 (Default)
19200
DCDi Mode
On (Default)
Off
Film Mode
On (Default)
Off
Exit Setup Menu
Press Factory
Selecting the Proper Scan Rate
For fixed panel display devices (DLP, LCD,
Plasma, etc.) optimum performance is achieved
by choosing the native resolution of the display.
For CRT based projectors there are a few
options. If the screen used is a wide angle
format, the projector geometry should be set for
Anamorphic sources. In general, the higher the
scan rate chosen, the better the image will
become, being more cinematic with increased
light output and contrast ratio. However, if too
high of a scan rate is chosen the image can
begin to appear soft as the scan lines start to
over lap. The bandwidth of the display must also
be considered when choosing a scan rate.
As a guide line, the following settings are
recommended:
Widescreen Applications
CRT Size Recommended Scan Rate
7”
800X600, 720p
8”
720p, 1024X768
9” 1024X768, 960p, 1280X1024, 1080p
4:3 Applications
CRT Size Recommended Scan Rate
7”
720p, 1024X768
8”
1024X768, 960p
9”
960p, 1280X1024, 1080p
Aspect Ratio Control
The DVP3000 has a unique Aspect Ratio control
to allow for maximum performance from a display
device. There are two types to choose from.
For proper operation, the correct
screen shape must be selected first
in the Setup menu!
Wide Angle Screens
This setting should be used on CRT projectors
with wide angle screens.
The projector geometry must be set
for Anamorphic sources!
Installation