Faroudja NRS-DVI Installation And Operation Manual - Quick Start
QUICK START
INSTRUCTIONS
The NRS-DVI requires only a few adjustments to be
set for proper operation. However, since the
processor must be integrated with a display device,
and the settings on one will affect the other, careful
attention must be made to the settings on both
products.
CONNECTIONS
Read the complete Owner’s Manual for the NRS-DVI
before installation.
Review the owner’s manual of the display. Most
display devices require specific settings to properly
integrate with an external processor.
Be sure to connect all sources to the proper inputs of
the NRS-DVI.
Note on DVDs: For proper aspect ratio and to insure
the highest quality image from the DVD player, be
sure to set the DVD screen shape to 16:9 in the DVD
player's Setup menu. See the DVD player's owner's
manual for details
Connect the proper cables from the output of the
NRS-DVI to the display device. Be sure the cables
are not crossed.
NRS-DVI SETUP
•
Plug the processor into the wall power.
The unit will go through initialization identifying
the output resolution.
•
Press the Menu button on the remote for five
seconds to enter the Setup menu.
•
Select Digital (DVI) or Analog (BNCs)output
•
Select output type when using the analog
output. RGBHV is recommended.
•
Composite Sync on H and Sync on Green
should be Off.
•
Select the screen shape of your display.
DISPLAY POSITION AND
ALIGNMENT
The next step in the setup procedure is to align the
display device to the processor. Be sure to follow all
directions for setting up the display found in the
display’s manual. Using a test DVD with the Safe
Area test pattern, align the image size, position and
blanking first using the controls found in the display
device. Only use these controls in the NRS-DVI if the
display device does not offer these controls or if there
is not enough range.
IMAGE ALIGNMENT
The final step is optimizing the image. Use a test
pattern DVD to optimize the display and processor.
Set the brightness and contrast using the controls in
the display.
Adjust the gray scale of the display using the color
temperature controls in the display.
Reduce the detail or sharpness control in the display
to 0 or 1 ( if available).
Using video material, adjust the Detail on the NRS-
DVI. Use of the Detail circuit is very depended on the
quality of the material being viewed. High quality
sources need less detail. DVDs or satellite sources
that are poor quality (compression artifacts)can be
cleaned up by reducing the detail level. Low
bandwidth sources such as VHS can be improved by
increasing the detail. Customized settings can be
stored in the User Presets.
a
QUICK START OPERATION MENU