Faroudja NRS-DVI Installation And Operation Manual - page 7
SETUP
5
Set: Screen Shape
Wide Screen / 4:3 / Wide 4:3
Note: This sets the processor for the screen shape of
the display to be used. If this is not set properly, the
aspect ratio selection for the different sources
located in the user menu will be incorrect.
• Wide Screen
-Choose this when the screen is
Widescreen and the projector will provide the
anamorphic vertical squeeze.
Example: A 16:9 plasma, a digital or CRT projector
set to Anamorphic using a wide angle screen or when
using a Panamorph lens, or a 1280x720 digital
projector.
• 4:3
– Choose this when the projector is 4:3
and the screen is 4:3
Example: using a 1024x768 digital projector on a 4:3
screen.
• Wide 4:3
-Choose this when the digital
projector operates as 4:3 and the screen is
Widescreen. (Not available on units scanning
at rates below 720p)
Example: A digital projector that has a 4:3 display
chip that locks the aspect ratio when sent the native
resolution and then displayed on a wide angle screen.
Set: RGB Input Sync
Sync-on-Green (Default) /TTL/Video
OSD (On Screen Display)
On (Default) /Off
OSD Timer
0-255 (30 default)
LCD Timer
6-255 (40 Default)
Note: setting the timer to 5 or lower sets the LCD
backlight to Always On.
Set: RS232 Echo
On (Default) /Off
Allows RSR232 characters to be sent back to the
controller.
Set: Component Input Standard
DVD (Default) /Professional (Betacam)
Note: Only use professional setting when using a
device that conforms to SMTPE Betacam levels
Note: Each input on the NRS-DVI can be activated or
deactivated to simplify operation so unused inputs
are not accessed when cycling through the inputs
with the remote control.
Set: Video Input
Enabled (Default) /Disabled
Set: S-Video Input
Enabled (Default) /Disabled
Set: RGB Input
Enabled (Default) /Disabled
Set: YCrCb Input
Enabled (Default) /Disabled
Set: Passthru Input
Enabled (Default) /Disabled
Note: The YPrPb inputs auto-detect signal type. All
480i/480p signals are sent to the upconverter. HDTV
signals are detected and routed to the pass-thru.
Disabling the Pass-Thru input does not affect the
YPrPb auto-detect feature.
Set: Passthru Transcode
Disable (Default) /Enable
YPrPb HDTV signals via the D15 input or the YPrPb
(BNC) inputs can be transcoded to RGB when this
feature is enabled.
Set: Restore Factory
Are You Sure? - Press Enter Key
Use this Function only in the event that
the processor no longer functions
properly and all other system checks have
been performed. This command will erase
all custom settings and restore the original firmware
configuration. Be sure to go back through the Setup
procedure for proper operation.
The next step in the setup procedure is to align the
display device. Be sure to follow all directions for
setting up the display found in the display’s manual.
Using a test DVD with the Safe Area test pattern,
align the image size, position and blanking first
using the controls found in the display device. Only
use these controls in the NRS-DVI if the display
device does not offer these controls or if there is
not enough range.