Fast 30400-KIT-EZ-EF Instructions Manual - page 12
Manual is about: Self Tuning Fuel Injection System
of
70
12
To assemble hoses, use the following procedure.
6. Cut hose to the desired length using a fine tooth saw or cut-off wheel. Be sure to clean the cut
edges of any loose material.
7. Lube the barbed end of the fitting with a light oil such as WD-40.
8. Slide a loose hose clamp over the hose so that it is ready to use when the hose has been
installed.
9. Place the fitting in a vise. Take care to not scratch the finish on the fitting. Placing a shop rag
over the vise jaws can be helpful. For straight fittings it is easiest to attach them to a male and
clamp the male fitting in the vise. This helps prevent the fitting from spinning during
installation.
10. Now, push the hose onto the fitting until the hose is flush with the plastic finisher.