Fast 30400-KIT-EZ-EF Instructions Manual - page 41
41
Inglese™ Setup
There are two main styles of Inglese™ systems: Down Draft (Eight-Stack) and Side Draft. If using a
Down Draft system, select the kit based on rated horsepower of the kit or the injector part number. If a
Side Draft system is used, choose between Single or Dual.
Injector Specs
To adjust a setting, touch the Injector lb/hr or Fuel Pressure PSI textbox. Then enter desired numbers
on the keypad and press Ent. The value will be sent to the selected textbox.
Number of Injectors – Choose from 4, 6 or 8. The button’s LED will indicate selection.
Injector lb./hr. @ 43 psi – This is the injector’s rated flow measured at 43 psi. Refer to the
injector’s datasheet to obtain this information. If the injector is rated at a different psi, a
conversion must be performed as shown below.
As an example, assume the injector’s flow rating is 65 lb/hr @ 58 psi.
The flow rating @ 43 psi is calculated as follows.