Fastech Ezi-servo plus-R User Manual - page 16
- 16 -
①
③
⑤
④
⑥
⑦
2)
Signal Level Assignment : ②
These buttons provide the user with functions that he can select the active level of signal
for the signal to be recognized to [ON]. He can click the button to the right of the signal
name and set the signal.
* Low Active : when the signal is set[ON] to 0 volt
* High Active : when the signal is set[ON] to 24 volt
3)
Save : ③
Output pin of CN1 can be set described same as input. All changed matters are temporarily
saved to the RAM area. To save them to the ROM area, the user must click ‘Save to ROM’
button. At this time, current parameter values are saved to the ROM area as well.
For more information of ‘I/O Monitoring’ and ‘I/O Logic Setting’ windows, refer to
「
User Manual-Text, 7. Control Input and Output Signal
」
.
4)
Load and Save to File :
④
Current I/O Logic setting status can be saved to external file and load from
External file. Refer to
「3.4 Save/Read toa File
」
.
7. Motion Test
To test the motor connected with the controller drive. The user can test motion for one axis.
He can test that the motor moves to the given position, and also simply transfer the motor
to one direction. The user can move the motor to the origin or the limit and then test its
sensor. At the position status and the axis status, the user can check the position, speed,
and status of the current axis.
7.1 Prior Movement
1) Click ‘Motion Test’ at the manin menu.
2) The window as shown to the right is
displayed.
3) Click , and the motor will be Servo
ON and the icon will be changed into .
At this time, the motor starts to be
electrified and the motor becomes
‘lock’ status.
4) Jog Operation
After setting jog related parameters,
click and press
it for a while, and the motor will be
operated to the setting direction.