Fastech Ezi-servo plus-R User Manual - page 18
- 18 -
②
①
③
7.4 Axis Status and Alarm
To display the current axis status. Each status is displayed
to On/Off. ‘On’ indicates in red and ‘Off’ indicates in
white.
1) When the motor stops operating and Inposition is finished,
the corresponding LED at the right figure is displayed
in red.
2) When an alarm occurs during operation, the corresponding LED is displayed in red. For more
information of alarm types, refer to
「
User Manual-Text, 7.4 Output Signal
」
.
3) After removing the alarm cause, click ‘ALARM RESET’ to check that the alarm is released.
Then change the LED into Servo ON again.
7.5 Stop Operating
7.5.1 Temporary Stop
Click ‘Pause’ button at the
I/O Monitoring window to
temporarily stop the motion.
When clicking the button again,
the motor restarts to operate.
If ‘Pause’ signal is set to
IN1~IN9, the actual external
signal must be supplied to [ON] status.
7.5.2 Complete Stop
When the motor needs to stop during operation, the button
as shown to the right is available. ‘STOP’ button includes
deceleration function, while ‘E-STOP’ button does not include deceleration function.